Testing the water. Swap TS150 for a 250/1?

Moderators: DAVID THOMPSON, phlat65, Brian

Testing the water. Swap TS150 for a 250/1?

Postby Tonyf » Fri Sep 19, 2014 10:37 am

Not sure what I'm going to do so testing the water.

I've got a nice TS150 which I've only just bought/ I've now sorted it out, 11 months MOT & Tax - new exhaust, rev counter, tyres etc but its really a 250/1 that I'm after...
Tonyf
 
Posts: 54
Joined: Fri Oct 04, 2013 3:02 pm

Re: Testing the water. Swap TS150 for a 250/1?

Postby andyzeder » Sat Sep 20, 2014 5:03 pm

I always fancied a TS 150 ...........apparently very underated ( arent al MZs ) :lol: I have a Supa 5 and wouldnt part with it its a far better bike than my ETZ 250 ( better low end torque) although the ETZ has 12 volts / better brakes ( even excellent) and autolube . Always been told of the 4 speed downfall with the 150 though ( too big a gap between 3rd and 4th) .Also th 250s can suffer from the "overun surge" which the smaller bikes dont have, but dont let this deter you from a 250 .Turning the idle air screw in so there,s no tick over can cure this to some extent or fitting an aftermarket "Mikuni" carb ££££££s Though . :roll:
andyzeder
 
Posts: 7
Joined: Sat Jun 21, 2008 1:29 pm
Location: Blackburn,Lancashire,England,UK

Re: Testing the water. Swap TS150 for a 250/1?

Postby Tonyf » Sun Sep 21, 2014 2:24 pm

Thanks Andy... I have a TS 250 attached to a sidecar, its the 4 speed model with a 5 speed engine in it.. Deffo want the Supa5 as a solo, just finding the right one now!
Tonyf
 
Posts: 54
Joined: Fri Oct 04, 2013 3:02 pm

Re: Testing the water. Swap TS150 for a 250/1?

Postby andyzeder » Sun Sep 21, 2014 3:21 pm

Have you used the full 5 speed engine or put the barrel/head from the 4 speed on a supa/5 bottom end ?
andyzeder
 
Posts: 7
Joined: Sat Jun 21, 2008 1:29 pm
Location: Blackburn,Lancashire,England,UK

Re: Testing the water. Swap TS150 for a 250/1?

Postby Tonyf » Sun Sep 21, 2014 4:08 pm

In the early 80s, it had a new engine fitted.
Tonyf
 
Posts: 54
Joined: Fri Oct 04, 2013 3:02 pm

Re: Testing the water. Swap TS150 for a 250/1?

Postby Tonyf » Mon Sep 22, 2014 10:16 am

Checking out the TS150 properly today - its got the original MZ toolkit. I saw the pump under the seat but well surprised to see the kit complete with puncture repair patch set in the side panel!
Tonyf
 
Posts: 54
Joined: Fri Oct 04, 2013 3:02 pm

Re: Testing the water. Swap TS150 for a 250/1?

Postby Tonyf » Wed Oct 01, 2014 3:31 pm

150 has gone, supa 5 acquired :-)
Tonyf
 
Posts: 54
Joined: Fri Oct 04, 2013 3:02 pm


Return to For Sale

Who is online

Users browsing this forum: No registered users and 17 guests