MZ/MuZ Riders

Posted: **Tue May 10, 2016 12:24 pm**

I sent an email to Motion Pro. We shall see. Any other sources for Silver Star cables?

Posted: **Tue May 10, 2016 1:30 pm**

Barnett Tool & Engineering makes custom cables as well. Basically, you'd send them your old cable and they'd duplicate it.
http://www.barnettclutches.com/service_center/default.aspx?cat_id=5

Posted: **Tue May 10, 2016 4:52 pm**

EDIT see posts further down the page for more info

http://americandirtbike.com/

and the cure a hydraulic clutch but not cheap

http://americandirtbike.com/magura.htm

dave

Posted: **Sun May 15, 2016 1:31 pm**

Any advice on how to replace the cable. It looks like I will have to remove the timing belt and so forth to access the cable at the engine?

Posted: **Sun May 15, 2016 5:00 pm**

You should just be able to remove the plastic plug(s) (with screwdriver slot in them) on the clutch case and unhook the lower end of the cable.

Posted: **Mon May 16, 2016 10:38 am**

Posted: **Mon May 16, 2016 11:39 am**

also here

Posted: **Mon May 16, 2016 11:43 am**

Thanks guys. I did figure it out and removed the cable. Now sending it to Motion Pro for a new one.

Source for cables? Clutch cable about to go!